Setup Menu - DeFelsko PosiTector SST Manuel De Demarrage Rapide

Masquer les pouces Voir aussi pour PosiTector SST:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Units
Allows the operator to change the displayed units for both
Temperature (°C or °F) and Surface Density (mg/m
Reset
Reset (menu Reset) restores factory settings and returns the
Gage to a known condition. The following occurs:
- All batches, stored measurements, batch names and screen
captures are erased.
- Calibration adjustments are returned to factory settings.
- The last stored background measurement ( γ
- Menu settings are returned to the following:
Memory = OFF
Bresle Mode = ON
Auto Dim = ON
Display = None
Patch Volume = 3.0ml
Perform a more thorough Hard Reset as follows:
1. Power down the Gage and wait 5 seconds.
2. Simultaneously press and hold the ( + ) and
buttons until the Reset symbol
This returns the Gage to a known, "out-of-the-box" condition.
It performs the same function as a menu Reset with the addition of:
- Bluetooth Pairing info is cleared.
- Menu settings are returned to the following status:
Flip Display = Normal
Backlight = Normal
Auto Sync .net = ON
White on Black = ON
Sound = ON
NOTE:
- Date, Time and WiFi settings are not affected by either Reset.
Patch Volume
Set the volume of water being used for the test (3.0ml default).
Use the (-)(+) buttons to decrease/increase the displayed value.
The patch volume is used to calculate surface density.

Setup Menu

Bluetooth & Stream = OFF
WiFi & Access Point = OFF
Surface Density units = mg/m
Temperature units = °C
Hi Res = OFF
appears.
Language = English
Battery Type = Alkaline
Bluetooth Smart = OFF
USB Drive = ON
8
or µg/cm
2
2
) is erased.
1
center
).
2

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Pt-sst1Pt-sstkitd1Pt-sstkitl1Pt-sstkitp1

Table des Matières