Basic Operation; Menu Operation - DeFelsko PosiTector SST Manuel De Demarrage Rapide

The PosiTector SST powers-up when the center navigation
button is pressed. To preserve battery life, the Gage powers
down after approximately 5 minutes of no activity (15 minutes
while in Bresle Mode (pg. 9). Alternatively, select Power Off
from the menu. All settings are retained.
Gage functions are menu controlled. To access the Menu,
power-up the gage, then press the center navigation button.
To navigate, use the Up and Down buttons to scroll vertically
to SELECT.
and
When powered-up, the PosiTector automatically
determines which probe is attached and does a self-check.
To disconnect disconnect a probe from a body, slide the
plastic probe connector horizontally (in the direction of the
arrow) away from the body. Reverse these steps to attach
a different probe. It is not necessary to power-down the
Gage when switching probes.
The PosiTector gage body accepts a wide variety of probe
types including magnetic, eddy-current and ultrasonic coating
thickness, surface profile, environmental, Shore hardness
durometer and ultrasonic wall thickness probes.
See www.defelsko.com/probes
PosiTector SST probes consist of a purpose-built test cell, optimized
for the range, resolution and test volume of the Bresle Method.
Conductivity measurements are compensated to 25°C
(77°F) using a built-in temperature sensor, and the
sample temperature is recorded for each measurement.
The probe can be used as a conventional conductivity
meter by unchecking Bresle Mode (pg. 9).

Basic Operation

Menu Operation

Press the ( + ) button to switch
pages in a multipage menu
Press the (-) button to return to
the previous menu or page.
Select Exit to exit from any menu.
Probes
2
Test
Cell