GENERAL SAFETY INSTRUCTIONS
Specific warnings and cautions to inform you about
potential exposure to bodily harm and machine
damage are listed below.
DANGER!
– To perform maintenance/repair procedures turn
the machine ignition key to the OFF position and
disconnect the battery.
– This machine must be used by qualified and
authorized personnel only. Children or disabled
people cannot use this machine.
– Keep the battery far from sparks, flames and smoke.
Explosive gases are vented during normal operation.
– Do not wear jewelry when working near electrical
components.
– Do not work under the lifted machine if it is not
securely supported.
– Do not operate the machine near dangerous,
flammable and/or explosive powders, liquids or
vapors.
– Battery charging produces explosive hydrogen
gas. Keep the hood open during battery charging
and perform the operation only in well-ventilated
areas and far from open flames.
– When wet (lead-acid) batteries are mounted on
this machine, do not tilt the machine more than
30° from its horizontal position. Doing so could
cause the highly corrosive acid to leak out of the
batteries. When it is necessary to tilt the machine
for maintenance, remove the battery(ies).
WARNING!
– Carefully read all maintenance/repair instructions
before
carrying
out
procedure.
– Take all necessary precautions to prevent hair,
jewelry and loose clothing from being caught in
moving parts.
– Do not smoke during battery charging.
– Do not leave the machine unattended with the
ignition key inserted and the parking brake
deactivated, if equipped,.
– Do not use the machine on surfaces with a gradient
greater than 2%.
– Do not wash the machine with pressurized water, or
with corrosive substances. Do not use compressed
air to clean this type of machine.
– Do not use the machine in extremely dusty areas.
– During the use of this machine take care not to
endanger other people.
146 0791 000(2)2004-02
any
maintenance/repair
– Storage temperature must be within +32°F - +104°F
(0°C - +40°C).
– The machine working temperature must be within
+32°F - +104°F (0°C - +40°C).
– Humidity range should be within 30% and 95%.
– Do not use the machine as a transport vehicle.
– Do not allow the brooms to operate while the
machine is stationary to avoid damaging the floor.
– In case of fire, use a powder extinguisher. Do not use
water.
– Do not bump into shelves or scaffolding where there
is a risk of falling objects.
– Adjust the operating speed according to the floor
conditions.
– Do not tamper with the machine safety guards; follow
the ordinary maintenance instructions scrupulously.
– Do not remove or modify the plates affixed on the
machine.
– In case of machine malfunctions ensure that these
are not caused by a lack of maintenance. Otherwise,
request assistance from the authorized personnel or
a Service Center.
– If parts must be replaced, request ORIGINAL spare
parts from a dealer or Authorized Retailer.
– To ensure proper machine operation and safety
conditions, the authorized personnel or Service
Center must carry out the Scheduled Maintenance
detailed in the related chapter of this Manual.
– The machine must be disposed of properly, at the
end of its cycle of life, because of the presence of
toxic-harmful materials (battery acid, oil, etc.), which
are subject to standards that require disposal in
special centers (see chapter "Scrapping").
– If the machine is used according to the instructions,
it will not produce dangerous levels of vibration. The
machine vibration level is below 2.5 m/s
UNPACKING
When the machine is delivered, check that the carton
and the machine were not damaged during shipping. If
damage is evident, keep the packing materials and
have it checked by the Parcel Service that delivered it.
Call the Parcel Service immediately to fill out a request
for a compensation for damages.
Please check that the following items have been
supplied with the machine:
1.
Technical documents: Sweeper Instruction for
Use Electronic Battery Charger Manual, Parts List
2.
Side broom fuse (1)
3.
Spare battery cables, terminal boots
4.
Electronics fuse (1)
OPERATOR MANUAL
2
.
3