Mounting The Controller - Allen-Bradley MicroLogix 1200 Notice D'installation

8 MicroLogix™ 1200 Programmable Controllers

Mounting the Controller

General Considerations
Most applications require installation in an industrial enclosure to reduce the
effects of electrical interference and environmental exposure. Locate your
controller as far as possible from power lines, load lines, and other sources of
electrical noise such as hard-contact switches, relays, and AC motor drives. For
more information on proper grounding guidelines, see the Industrial Automation
Wiring and Grounding Guidelines publication 1770-4.1.
ATTENTION: Vertical mounting is not recommended due to
thermal considerations.
!
ATTENTION: Be careful of metal chips when drilling mounting
holes for your controller or other equipment within the enclosure or
!
panel. Drilled fragments that fall into the controller could cause
damage. Do not drill holes above a mounted controller if the
protective debris strips have been removed.
1762-IN006A-ML-P