Overview - Allen-Bradley MicroLogix 1200 Notice D'installation

Overview

MicroLogix™ 1200 Controllers are suitable for use in an industrial environment
when installed in accordance with these instructions. Specifically, this equipment
is intended for use in clean, dry environments (Pollution degree 2
circuits not exceeding Over Voltage Category II
Install your controller using these installation instructions.
ATTENTION: Do not remove the protective debris strip until
after the controller and all other equipment in the panel near the
!
controller is mounted and wiring is complete. Once wiring is
complete, remove protective debris strip. Failure to remove strip
before operating can cause overheating.
ATTENTION: Electrostatic discharge can damage semiconductor
devices inside the controller. Do not touch the connector pins or
!
other sensitive areas.
(1) Pollution Degree 2 is an environment where, normally, only non-conductive pollution occurs except that
occasionally a temporary conductivity caused by condensation shall be expected.
(2) Over Voltage Category II is the load level section of the electrical distribution system. At this level transient
voltages are controlled and do not exceed the impulse voltage capability of the product's insulation.
(3) Pollution Degree 2 and Over Voltage Category II are International Electrotechnical Commission (IEC)
designations.
MicroLogix™ 1200 Programmable Controllers
debris strip
(2)
(IEC 60664-1).
5
(1)
) and to
(3)
1762-IN006A-ML-P