Hazardous Location Considerations - Allen-Bradley MicroLogix 1200 Notice D'installation

Hazardous Location Considerations

This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D or
non-hazardous locations only. The following ATTENTION statement applies to
use in hazardous locations.
ATTENTION: EXPLOSION HAZARD
!
• Substitution of components may impair suitability for Class I,
Division 2.
• Do not replace components or disconnect equipment unless
power has been switched off or the area is known to be
non-hazardous.
• Do not connect or disconnect components unless power has
been switched off or the area is known to be non-hazardous.
ATTENTION: This product must be installed in an enclosure. All
cables connected to the product must remain in the enclosure or be
!
protected by conduit or other means.
Use only the following communication cables in Class I, Division 2 hazardous
locations.
Cable Listing
Environment Classification
Class I, Division 2 Hazardous Environment
MicroLogix™ 1200 Programmable Controllers
Communication Cables
1761-CBL-PM02 Series C or later
1761-CBL-HM02 Series C or later
1761-CBL-AM00 Series C or later
1761-CBL-AP00 Series C or later
2707-NC8 Series B or later
2707-NC10 Series B or later
2707-NC11 Series B or later
7
1762-IN006A-ML-P