Programming The Rf Remote Transmitter - CDVI SASIC Manuel D'installation

INSTALLATION MANUAL
SASIC
Interlocking controller
7.3 Programming
the RF remote transmitter
Description of the Radio Frequency (RF) remote transmitter
Channel Associated function
1 Opens door 1 (timed opening)
2 Opens door 2 (timed opening)
3 Blocking or unblocking the locking devices of the two doors
4 Arms or disarms the general alarm
Programming RF remote transmitter
channels on the embedded radio module
To use the remote transmitter,
the DipSwitch_2_SW8
on the SASIC board must be in the ON
position.
The timed openings
are those set on the SASIC central unit,
either by dipswitch or PC.
When a door is locked by a control panel or
by the remote transmitter,
it may be opened either by an external rea-
der, or by the remote transmitter.
If large distance is a problem,
connect a remote aerial (Ref. SEA433).
L4
L3
DL4
DL3
L2
DL2
L1
DL1
Fig. 1: RF receiver
1. Programming channel 1 (L1)
- Press the RF button once (see the position
on the wiring diagram on page 33)
until the warning light L1 lights up.
- Release the RF button.
- Press the key 1 on each emitter
to be programmed.
- After a few moments, the warning light L1
goes off and the programming is complete.
2. Programming channel 2 (L2)
- Press the RF button once until
the warning light L1 comes on.
- Release the RF button then press it again
until the warning light L2 comes on.
- Press the key 2 on each emitter
to be programmed.
- After a few moments, the warning light L2
goes off and the programming is complete.
3. Programming channel 3 (L3)
- Press and release the RF button
until the warning light L3 comes on.
- Release the RF button.
- Press the key 3 on each emitter
to be programmed.
- After a few mo ments, the warning light L3
goes off and the programming is complete.
4. Programming channel 4 (L4)
- Press and release the RF button
until the warning light L4 comes on.
- Release the RF button.
- Press the key 3 on each emitter
to be programmed.
- After a few moments, the warning light L4
goes off and the programming is complete.
Deleting a channel on the RF receiver
- First of all, select the channel
you wish to delete from the receiver.
To do so, press the RF button.
- Next, press the key on the emitter
corresponding to the channel number.
The warning lights L3 and L4 fl ash twice
to confi rm deletion.
Repeat the same procedure
for each of the emitter keys.
EN
cdvi.com
47
cdvigroup.com