Programming; Card Enrollment Procedure (Add Or Delete Cards Without A Computer); Programming Card - CDVI A22K Mode D'emploi

5] PROGRAMMING

The stand-alone card enrollment allows you to add or delete user cards at a reader.
CARD ENROLLMENT PROCEDURE
(ADD OR DELETE CARDS WITHOUT A COMPUTER).
1. Present the MASTER card to a reader, The door will unlock.
2. Within 5 seconds, present the PROGRAMMING card to the reader.
Reader LEDs will begin flashing in sequence (2 Red flashes + 2 Green).
Enrollment mode is active .
3. Present cards, one by one, to the reader.
NEW cards will be ADDED.
Green LED will flash and a quick beep will be emitted.
Each new card will create a user and attribute the card to the user
EXISTING cards will be DELETED. Red LED will flash and a long beep will be emitted.
4. Present the PROGRAMMING card again to stop enrollment mode.
The flashing sequence (2 Red flashes + 2 Green) will stop.
The card enrollment learning mode ends when no new card is presented for 5 minutes.
For other card enrollment methods, refer to the "ATRIUM Software" user guide.
58
A22K
Contrôleur 2 portes
FR
Master Card
Programming card