Kettler STARTRIKE Instructions De Montage page 6

GB
■ Please bear in mind that children are very often not able to judge their own capabilities
and certain (dangerous) situations. Also consider that a natural urge to play plus their tem-
perament may lead children into unforeseen situations for which the manufacturer cannot
be held responsible.
■ This wheeled toy does not have lights. It is dangerous to use it in the dark.
■ When mounting the product please take the recommended torque information into
account (M = xx Nm).
Handling
■ Before use always check that all screws and plug-in connections and respective safety
devices fit correctly.
■ Instruct children in the correct use of the product, and draw their attention to possible dan-
gers.
■ Please note that pedals on any wheeled toy without freewheeling appliance will turn even
if the product is being pushed or is coasting.
■ This wheeled toy does not have a so-called parking brake. Therefore secure the vehicle
against rolling away. Do not leave children, who are not old enough to use the wheeled
toy, unattended on a product.
■ If this product can be adjusted please adapt it to your child's height.
■ Do not transport anything on this product.
■ Never use corrosive or abrasive substances to clean the toy. Never use substances which
may cause pollution of the environment.
■ Lubricate the bearing sleeves of the wheels and the handlebars with a few drops of oil
every two or three months.
■ For models with push bars: Always ensure that the push bar fits correctly in the adaptor,
and locks. Do not hang any weights on the bar! The vehicle may tip over, and your child
may be hurt. The push bar is intended for adult use only, do not pass responsibility for
children on to other children. For free play time take the push bar off for safety reasons.
Assembly of the toy vehicle
■ Please ensure that the vehicle will only be used for playing when assembly has been car-
ried out correctly, and checked, by an adult.
■ The toy vehicle must be assembled carefully by an adult person. Study the assembly
instructions carefully before beginning work. Assemble the vehicle in the exact sequence
shown by the letters in the diagrams. This is essential for the safe function and use of the
toy vehicle.
■ Please note that there is always a danger of injury when working with tools or doing
manual work. Therefore please be careful when assembling this machine.
■ Bolt all the parts together loosely at first, and check that they have been assembled cor-
rectly. Tighten the locknuts by hand until resistance is felt, then use spanner to finally tigh-
ten nuts completely against resistance (locking device). Then check that all screw connec-
tions have been tightened firmly. Attention: once locknuts have been unscrewed they no
longer function correctly (the locking device is destroyed), and must be replaced.
■ When assembling plastic grips: The grips can be pushed onto the handlebars more easily
if they are first soaked in warm water.
6