Step 5: Remove The Shock Sleeves And Shipping Brace; Step 6: Wipe Out Inside Of Washer Drum; Step 7: Plug In The Washer; Step 8: Check Installation - Alliance Laundry Systems H370I Manuel D'installation

Step 5: Remove the Shock Sleeves and
Shipping Brace
Remove front access panel by removing the two
screws.
Remove bolts and lockwashers from shipping brace
with 9/16 in. wrench and remove brace. Remove shock
sleeves by pulling on the yellow rope.
Remove label from front side of front access panel and
place on backside of front access panel.
NOTE: The shipping brace, bolts, lockwashers and
shock sleeves should be saved and MUST be
reinstalled whenever the unit is moved more than
four feet. Do not lift or transport unit from front or
without shipping materials installed.
Store the shipping materials in the bag provided in the
accessories bag. Save materials for use whenever the
unit is moved.
NOTE: The shipping materials MUST be reinstalled
whenever the washer is moved. Refer to Moving
Washer to a New Location section for instructions.
Reinstall front access panel.
4
3
1 Shock Sleeves
2 Motor Mount
3 Bolts and Lockwashers
4 Hooked End of Shipping Brace
Figure 11
801605
1
2
H336I
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Step 6: Wipe Out Inside of Washer Drum

Before using the washer for the first time, use an all-
purpose cleaner, or a detergent and water solution, and
a damp cloth to remove shipping dust from inside the
drum.
Figure 12

Step 7: Plug In the Washer

Refer to section on Electrical Requirements and connect
the washer to an electrical power source.
Plug cord into separately fused 15 Amp circuit.
Figure 13

Step 8: Check Installation

Refer to Installer Checklist on the back cover and
make sure that unit is installed correctly.
Installation
H337I
D254I
D254I
11