Operator Safety Instructions; Inspections And Maintenance - Güde GSE 5500 DSG Traduction Du Mode D'emploi D'origine

Fig. 4
GSE 5500 DSG (#40586) Generator Turning Off
Fig. 5

Operator Safety Instructions

See General Safety Instructions and Initial Operation Safety Instructions.

Do not use the machine until you have read the instruction manual carefully.

Observe any safety instructions included in the manual.

Be responsible to the others
Troubles – Causes – Troubleshooting
Trouble Cause
1.
2.
The engine will not
3.
start up.
4.
5.
1.
Engine runs unevenly
2.

No current from

generator.


Inspections and Maintenance

Regular cleaning and maintenance is essential for perfect functioning and long service life of the
unit.
Troubleshooting
Fuel cock closed 1.
No fuel 2.
Too little oil in the tank 3.
Air in oil pipeline 4.
Battery too weak 5.
Poor fuel 1.
Air in oil pipeline 2.
1.
Short circuit
If the light indicator is on :
Defective cable
2.
Loose cable
3.
4.

Disconnect the appliance from the unit before
stopping the engine.

Close the fuel tap (OFF).

Turn the fuel cock in (OFF) position.
CAUTION! Always pill the key from the unit
when the generator is out of use and keep it at a
safe place. If the engine is not used for a longer
period of time, it must be switched off, too.
Make sure that the fuel cock on/off switch are in on position
Make sure that there is enough fuel in the tank.
Replenish the oil
Have the oil pipeline blown through
Charge the battery with appropriate charger
Make sure that the used fuel is correct.
Have the oil pipeline blown through
If the light indicator is off, the defect is impossible to be
cleared by yourself. .
Press the overloading protection for the required output.
Check the connection.
Check whether a short circuit or overloading is not the
cause.
19