Operator Safety Instructions; Inspections And Maintenance - Güde GSE 5501 DSG Traduction Du Mode D'emploi D'origine

Operator Safety Instructions

See General Safety Instructions and Initial Operation Safety Instructions.

Do not use the machine until you have read the instruction manual carefully.

Observe any safety instructions included in the manual.

Be responsible to the others
Troubles – Causes – Troubleshooting
Trouble Cause
1.
2.
The engine will not
3.
start up.
4.
5.
1.
Engine runs unevenly
2.

No current from

generator.


Inspections and Maintenance

Regular cleaning and maintenance is essential for perfect functioning and long
service life of the unit.
No smoking in the course of the described jobs.
Never work close to sparks, flames or open fire.
Scheduled Maintenance and Inspections
Air Filter
The air filter should be cleaned every 50 hrs of operation.

Loosen the service cover screwing.

Remove the cover.

Remove the air filter.

Clean the filter with spirit or ethanol

Drop a small amount of oil on the air filter and compress it.

Put the filtration cartridge back and put the housing on.
Fuel Screen

Remove the lid from the filler hole.

Pull the fuel screen from the filler hole.

Clean the filter with spirit or ethanol

Dry it with a soft cloth.

Put the filter back in the filler.

Replace the lid on the filler.
Oil Replacement

Let the engine heat up.

Unscrew the filler plug.

Remove the discharge screw and drain the used oil into a suitable container.

Check packing and replace it if necessary. Screw the discharge screw in and pour new oil in.

Screw the filler neck again on.
Troubleshooting
Fuel cock closed 1.
No fuel 2.
Too little oil in the tank 3.
Air in oil pipeline 4.
Battery too weak 5.
Poor fuel 1.
Air in oil pipeline 2.
1.
Short circuit
Defective cable
2.
Loose cable
3.
4.
Make sure that the fuel cock on/off switch are in on position
Make sure that there is enough fuel in the tank.
Replenish the oil
Have the oil pipeline blown through
Charge the battery with appropriate charger
Make sure that the used fuel is correct.
Have the oil pipeline blown through
If the light indicator is off, the defect is impossible to be
cleared by yourself. .
If the light indicator is on :
Press the overloading protection for the required output.
Check the connection.
Check whether a short circuit or overloading is not the
cause.