GOLDONI EURO RS Série Mode D'emploi Et Entretien page 82

Engage front wheel drive if the tractor has it.
8. Check to make sure that all revolving parts on the machines (PTO, Cardan
couplings, pulleys etc) are fully guarded. Do not wear clothing which could be
pulled into the machine's or the equipment's moving parts.
9. Do not run the engine in an enclosed area: the engine exhaust is poisonous.
10.Do not leave the malchine with engine running near flammable substances.
11.Before driving the machine, check to be sure that there are no bystanders or
animals in its working range.
12.Do not leave the driving seat with the engine running and/or the key in the
ignition.
13.Whenever the PTO is in use, the drive shaft must be covered by the special
guard.
14.From time to time, with the engine shut off, wheel and roll bar fixing nuts and
screws.
15.After any maintenance work, grease and remove the grease from the engine
to eliminate the risk of a fire.
16.Keep hands and other parts of the body away from holes or leaks in the
hydraulic system. The hydrualic fluid from the leak is under pressure and can
cause serious injury.
17.To not carry any other equipment on the machine apart from that supplied
with it. Do not carry passengers in addition t o the driver.
18.Do not use the differential lock near or in curves and avoid using it in fast
gears or with engine running at high rpm.
19.Do not get on or off the machine while it is moving.
20.Avoid tight steering angles when towed implements are mounted and the
drive shaft is under strain since the coupling could be damaged.
21.Do not use the 3-point linkage on the lift as a hitch.
22.Regulate the hitch in its lowest possible positions to prevent the machine
from rearing.
23.During transhipments with equipment coupled on the 3-point linkage, tension
the chains and keep the lift raised.
24.The operator must check if every part of the tractor and, especially the
safety devices, are in good working condition and perform to specs. They
should be kept in perform working condition. If you note any defects or
malfunctioning, fix or repair them in good time. If necessary contact your
nearest Assistance Centre. Failure to observe these instructions will release
the manufacturer from all liability.
81