Environmental Protection; Available Accessories - Jet ELITE EVC-400DGSP Mode D'emploi

Problem
Sawblade will not start
* WARNING: Some corrections may require a qualified electrician.

13.0 Environmental Protection

Protect the environment.
Dispose all packaging material in an environmental friendly manner.
Your appliance contains valuable materials which can be recovered or recycled. Please leave it at a specialized institution.

14.0 Available Accessories

Refer to the JET price list.
Possible Cause
Machine unplugged.
Fuse blown, or circuit breaker
tripped.
Cord damaged.
Transformer
Contactor
Thermal relay
Blade guard not closed
Sawblade access cover not
closed
Motor
Belt
Check all plug connections.
Replace fuse, or reset circuit breaker.
Replace cord.
Check that the correct voltages are present both on the input
and output. Otherwise replace.
Check that all 3 phases are present both on the input and
output.
Check that it is not jammed, that it closes when powered and
that it is not causing short circuits. Replace if any of these
problems are found.
Check that all 3 phases are present both on the input and
output.
Check that it responds when the reset coil is closed.
If it has tripped to protect the motor, check the amperage
setting, reset, and check the motor. Replace if necessary.
Close the guard
Close the cover
Check that motor windings have not burnt, that they measure
the same resistance between all phases.
Check that the motor turns freely.
Check that there is no moisture in the connection terminal
box.
The winding can be rewound or motor be replaced.
Check that belt is in good condition and properly tensioned
Table 2
15
Correction *