Setup And Assembly; Unpacking And Clean Up; Shipping Contents; Assembly - Jet ELITE EVC-400DGSP Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6.0 Setup and Assembly

WARNING:
Read and understand the entire contents of this manual
before attempting assembly or operation. Failure to comply
may cause serious injury.

6.1 Unpacking and clean up

Remove all contents from shipping crate and compare parts to
the contents list in this manual. If shipping damage or any part
shortages are identified, contact your distributor. Do not
discard crate or packing material until drill press is assembled
and running satisfactorily.
Clean all rust protected surfaces with kerosene or a light
solvent. Do not use lacquer thinner, paint thinner or gasoline,
as these can damage plastic components and painted surfaces.

6.2 Shipping contents

1
Machine
1
Saw blade 405 x 30 x 3.2 mm – 120T
1
Owner's manual
1
Parts list
6.3 Tools required for assembly:
None
6.4 Compressed air connection
Connect air supply to the quick connect coupler (L, Figure 6-1).
Figure 6-1: Compressed air connection
Compressed air supply ........................................ 6.5bar (90psi)
WARNING:
Continuous compressed air supply must be assured.

7.0 Electrical Connections

WARNING:
All electrical connections must be done by a qualified
electrician in compliance with all local codes and ordinances.
Failure to comply may result in serious injury.
The EVC-400DGSP Aluminium Mitre Circular Saws are rated at
3~400V, PE, 50Hz power supply. The machines comes with a
plug designed for use on a circuit with a grounded outlet.
Mains connection and any extension cords and plugs used
must comply with the information on the machine license
plate.
The mains connection must have a 16A surge-proof fuse.
Only use extension cords marked H07RN-F, with wires 1,5mm
or more.
The total length of cord may not exceed 18 Meter
Power cords and plugs must be free from defects.
Connections and repairs to the electrical equipment may only
be carried out by qualified electricians.
The machine is equipped with 1.8m power cord and plug.
Before connecting to power source, be sure main switch is in
off position.
CAUTION:
The saw blade must run towards the fence.
If the direction of rotation is not correct, the phase converter
inside the CEE Euro plug must be pushed in and turned 180°.

7.1 Grounding instructions

This tool must be grounded. In the event of a malfunction or
breakdown, grounding provides a path of least resistance for
electric current to reduce the risk of electric shock. This tool is
equipped with an electric cord having an equipment-grounding
conductor and a grounding plug. The plug must be inserted into
an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
WARNING:
Improper connection of the equipment-grounding conductor
can result in a risk of electric shock. Check with a qualified
electrician or service person if you are in doubt as to whether
the outlet is properly grounded. Do not modify the plug
provided with the tool.
The green/yellow conductor is the equipment-grounding
conductor. If repair or replacement of the electric cord or plug
is necessary, do not connect the equipment-grounding
conductor to a live terminal.
Use only 5-wire extension cords with grounding plugs.
Repair or replace damaged or worn cord immediately.
9
2

Publicité

Table des Matières
loading

Table des Matières