Turning The Radio On / Off; Selecting A Playback Source; Using The Radio's Main Menu; Using The Source Button - PERFECTPRO NETBOX Mode D'emploi

7. The Network Wizard will now
scan for networks and show a
list of Wi-Fi networks that are
detected by the radio along
with an option to scan again
and an option to manually
c o n f i g u r e t h e n e t w o r k
connection.
Use the Tuning knob to select one of the options:
● [Name of a Wi-Fi network]: Select the name of a Wi-
Fi network to proceed to the password entry screen
for the selected network.
● [Rescan]: Select this option to scan for Wi-Fi
networks again.
● [Manual config]: Select this option to manually
configure the radio's internet connection (DHCP
enabled / disabled, SSID, authentication method and
password).
8.
If you have connected to a Wi-Fi network, an icon
indicating the network's signal strength will appear in
the bottom bar of the radio's display.
9.
You have now completed the Setup Wizard and are
ready to start using your NETBOX. After completing the
Setup Wizard, the radio's Main menu will be shown on
the display.
Notes:
● All of the radio's menus can be navigated by
rotating the Tuning knob to select an option and
then pressing the Tuning knob to open or confirm
the selection.
● During the Setup Wizard, the radio's default and
recommended settings are indicated using an
asterisk.
● In order to use any of the radio's internet features
or to control the radio using the UNDOK app, the
radio must be connected to a network that has
internet access.

Turning the radio on / off

The NETBOX can be switched on or off by pressing
the Power button. After the radio is turned on, it will
automatically select the last used source. When the radio
is turned off, it will switch over to the Standby mode.

Selecting a playback source

There are two ways to select a playback source:

Using the radio's Main menu

Open the radio's Main menu by pressing and holding the
Info / Menu button, select [Main menu] by rotating the
Tuning knob and open the Main menu by pressing the
Tuning knob. Next, select the playback source by rotating
the Tuning knob and press the Tuning knob to confirm
your choice (refer to chapter 15 "Using the Main menu" for
details regarding the radio's Main menu).

Using the Source button

Repeatedly press the Source button to select the desired
mode.
SSID
youmib1919
youmib1920
youmib1921
[Rescan]
[Manual config]
4. Controlling the radio using the UNDOK
app
Aside from controlling your NETBOX with the
buttons on the radio, it can also be controlled
from a smart device using the UNDOK app. The
UNDOK app offers an intuitive and easy to use
user interface, allows you to configure many of
the radio's settings and is available for Android and iOS.

Using the UNDOK app to control the radio

Follow these steps to use the UNDOK app to control the
radio:
1. Download and install the UNDOK app for your device
by searching for "UNDOK" in Apple's App Store or the
Google Play Store.
2. Make sure the radio and your smart device are
connected to the same network. Instructions for
connecting the radio to your network can be found
in the "Performing the radio's initial setup" section of
chapter 3 "Getting started".
3. Open the UNDOK app on your smart device.
After starting the UNDOK app, your NETBOX should
appear on the home screen of the app with the name
UNDOK
Germany
GB
07