Log Placement - Napoleon XIR3N Manuel D'installation

4.3

LOG PLACEMENT

FAILURE TO POSITION THE LOGS IN ACCORDANCE WITH THESE DIAGRAMS OR FAILURE TO USE
ONLY LOGS SPECIFICALLY APPROVED WITH THIS APPLIANCE MAY RESULT IN PROPERTY
LOGS MUST BE PLACED IN THEIR EXACT LOCATION IN THE APPLIANCE. DO NOT MODIFY THE
PROPER LOG POSITIONS, SINCE APPLIANCE MAY NOT FUNCTION PROPERLY AND DELAYED
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
PHAZER
logs and glowing embers exclusive to Napoleon, provide a unique and realistic glowing effect that
TM
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing
effect.
Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
pigments burn in during the heat activated curing process.
NOTE: Log support brackets are supplied in the manual baggie.
A. Place the rear log into position
lining up the holes in the bottom with
the studs located at the rear of the
firebox. Ensure it is tight to the burner.
D. Place the left front log into
position, lining up the 2 holes in the
bottom with the studs located on
the left side of the burner.
G. Position the right charcoal strip
in front of the right front log, lining
up the 2 holes in the bottom with
the 2 front right studs.
WARNING
!
DAMAGE OR PERSONAL INJURY.
IGNITION MAY OCCUR.
PIN
LOG SUPPORT
B. Insert a pin (supplied) into the
right end of the left middle log
using the left log support in front
of the left middle log to hold log in
place.
E. Place the right front log into
position, lining up the 2 holes in the
bottom with the studs located on
the right side of the burner.
H. Position a pin into the left side
hole of the left middle log, move
the left crossover log into position,
lining up the top hole with the pin.
76.1A
C. Insert the right middle log end
onto the left log pin using the right
log support in front of the right
middle log to hold log in place.
Adjust the log supports tight to
these logs to hold them in an
upright position and ensure they are
tight to the burner.
F. Position the left charcoal strip in
front of the left front log, lining up
the 2 holes in the bottom with the
2 front left studs.
I. Position a pin into the right side
hole of the right middle log, move
the right crossover log into position,
lining up the top hole with the pin.
W415-1343 / A / 11.18.16
13
EN