Xir3 Operation; General Transmitter Layout; Appliance Operation; Hand Held Remote Operations - Napoleon XIR3N Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

18
6.2

XIR3 OPERATION

EN
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT WITH

6.2.1 GENERAL TRANSMITTER LAYOUT

TRANSMISSION
LOW BATTERY
ALARM
TEMPERATURE SET POINT/ LEVEL/ STATUS
FLAME

6.2.2 APPLIANCE OPERATION

A.
Install 4 AA batteries into the receiver battery bay as indicated on the battery cover (+/-). (Only required
as back up to household electricity).
B.
Place the 3 position slider switch of the receiver in the "Remote" position.
C.
Using the end of a paper clip, or other similar object, insert the end of the paper clip into the hole
marked "PRG" on the receiver front cover. The receiver will "beep" three (3) times to indicate that it is
ready to synchronize with the transmitter.
D.
Install the 3 AAA batteries in the transmitter battery bay, located on the base of the transmitter.
With the batteries already installed in the transmitter, push the "ON" button. The receiver will "beep"
four times to indicate the transmitter's command is accepted and set to the particular code of that
transmitter. The system is now initialized.

6.2.3 HAND HELD REMOTE OPERATIONS

A.
Press the ON/OFF key on the transmitter. The transmitter
display will show all active icons on the screen. A single
"beep" from the receiver will confi rm reception of the
command.
W415-1343 / A / 11.18.16
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
THE GLASS DOOR OPENED OR REMOVED.
CHILD SAFETY
LOCK OUT
ROOM
TEMPERATURE
FAN
AUX. OUTPUT
SPLIT VALVE
WARNING
!
35.2A
BLUE LCD DISPLAY
ON/OFF KEY
TEMPERATURE KEY
UP/DOWN
ARROW KEY
MODE KEY
35.4A

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Xir3p

Table des Matières