Siebert SX102 Série Manuel D'utilisation page 22

Control
The units must be parameterized before they can be controlled. Parameterization
occurs in a menu (see 'Parameterization').
Data format
The first two bytes (byte 0 to 1) contain the formatting of the characters to be
displayed (decimal point, brightness, flashing, blanking, display test):
7 6 5
: : :
: : :
: : :
: : :
: : :
: : :
: : :
: : :
: : 0 Flashing of the entire display off
: : 1 Flashing of the entire display on
: :
: 0 Blanking of the entire display off
: 1 Blanking of the entire display on (Priority over flashing)
:
0 Display test off
1 Display test on (Priority over flashing and blanking)
The following bytes (from byte 2 onwards) contain the ASCII characters to be
displayed. The number of these bytes depends on the character number of the units:
Units with 6 characters (SX102-06/18/0x-00x/0B-K0)
Byte:
Character: C6
Units with 8 characters (SX102-08/18/0x-00x/0B-K0, SX102-08/30/0x-00x/0B-K0)
Byte:
Character: C8
Units with 14 characters (SX102-14/18/0x-00x/0B-K0)
Byte:
Character: C14 C13 C12 C11 C10 C9
22
Byte 0
4 3 2 1
:
: C12 C11 C10
:
: –––––––––– Flashing of individual digits (0 = off, 1 = on) –––––––––––
:
0 Standard display brightness
1 Reduced display brightness
2 3 4 5
C5 C4 C3
2 3 4 5
C7 C6 C5
2 3 4 5
0 7 6
C9 C8 C7
6 7
C2 C1
6 7 8 9
C4 C3 C2 C1
6 7 8 9
C8 C7
Byte 1
5 4 3 2
C6 C5 C4 C3
10 11 12 13
C6 C5 C4 C3
BAL SX102 PFB M 1.00
1 0
C2 C1
14 15
C2 C1