Linkable Functions; Switching The Switcher Bus Materials; Focus Assist Function - Panasonic AW-HS50E Mode D'emploi

7. Function for linking up with the remote camera controller

7-2. Linkable functions

7-2-1. Switching the switcher bus
materials
The unit's bus materials can be switched in tandem with the
camera selection operations performed by the AW-RP50.
[Settings established at the AW-RP50]
 Set the remote cameras that correspond to the unit's
image input.
(On the AW-RP50, SDI IN 1 to 4 are displayed as
INPUT1 to 4 while DVI-IN is displayed as INPUT5.)
 Enable the bus switching function (BUSCONT).
 Set AUX, PVW, PinP or KEY (key fill bus) as the bus
targeted for switching.
Unit's AUX image
output
AW-HS50
CAM1
Outputting the image of
the multi view display
USER button indicator:
Off
AW-RP50

7-2-2. Focus assist function

It is possible to switch between the multi view display screen
and camera image full screen with a single AW-RP50 button
operation.
It is the AUX bus materials that are targeted for switching.
[Settings established at the AW-RP50]
 Set the remote cameras that correspond to the unit's
image input.
(On the AW-RP50, SDI IN 1 to 4 are displayed as
INPUT1 to 4 while DVI-IN is displayed as INPUT5.)
 Assign the focus assist function (FASIST) to one of the
USER buttons on the AW-RP50.
[Operations performed at the AW-RP50]
Each time the USER button to which FASIST has been
assigned is pressed, the indicator of the USER button
turns on or off, and the AUX bus material is switched.
When the USER button indicator has lit:
The image of the remote camera selected by the
CAMERA STATUS/SELECTION button is selected as
the AUX bus material.
When the USER button indicator has gone off:
The image of the multi view display is selected as the
AUX bus material.
FASIST: OFF
FASIST: ON
Outputting the selected camera image using
the CAMERA STATUS/SELECTION button.
53 (E)
USER button indicator:
Lights
AW-RP50