Setting The User Buttons - Panasonic AW-HS50E Mode D'emploi

1. Basic operations

1-8. Setting the USER buttons

Menu item functions can be assigned to the USER 1[3]
button and USER 2[4] button for use later.
Up to four functions can be assigned from USER1 to
USER4.
The following functions can be assigned to the USER buttons (USER 1 and USER 2).
No. Item
1 PinP Preset
2 WIPE Preset
3 PinP PVW
4 KEY PVW
5 GPI Input
6 GPI Output
7 CamCont Link
8 AUX Transition
9 PinP Transition
10 EFFDSLV
11 StrFMEM1
12 StrFMEM2
13 No Asign
Even when functions have been assigned to the USER button, the assigned functions will be disabled in the following situations,
and direct operations using the USER buttons and OSD/TIME dial will be enabled.
  When the chroma key marker is displayed
  When the submenu [2] WIPE Menu is displayed
  When the submenu [3] PinP Menu is displayed
  When the submenu [5] KEY Adjust Menu is displayed
 Refer to "2-5-6. Direct operations using the USER buttons and OSD/TIME dial" (<Basics> Operating Instructions).
This item can be set in the [USER1] only.
When it is set, [USER1] to [USER4] can all be used for calling the data in the PinP preset memories.
This item can be set in the [USER1] only.
When it is set, [USER1] to [USER4] can all be used for calling the data in the WIPE preset memories.
The PinP image is output to the PVW image.
KEY is output to the PVW image.
The GPI input is enabled or disabled.
The GPI output is enabled or disabled.
Link control with the AW-RP50 is set to ON or OFF.
The AUX transitions are enabled or disabled.
The PinP transitions are enabled or disabled.
Effect dissolve is enabled or disabled.
The images of the AUX bus are imported into the frame memory (FMEM1).
The images of the AUX bus are imported into the frame memory (FMEM2).
No item assigned
23 (E)
The functions registered in [USER1] and [USER3] are
assigned to the USER 1 button, and the functions registered
in [USER2] and [USER4] are assigned to the USER 2
button.
While the SHIFT button is held down, the function registered
in [USER3] or [USER4] can be selected.
The button indicator is lit when the functions assigned to
the button are enabled, and it is off when the functions are
disabled.
Each time a USER button is pressed, its functions are
switched between enabled and disabled.
Function