Setting The Material Names; Setting The Freeze Method - Panasonic AW-HS50E Mode D'emploi

2. Input/output signal settings

2-1-3. Setting the material names

[10.1] Input Menu/SDI-IN1
5. Name
[10.2] Input Menu/SDI-IN2
5. Name
[10.3] Input Menu/SDI-IN3
5. Name
[10.4] Input Menu/SDI-IN4
5. Name
[10.5] Input Menu/DVI-IN
3. Name
These are used to set the material names.
Material names can be set when "Preset" or "User" has been
selected as the material name type setting.
  The material names are merely displayed (they cannot be
set) when "Default" or "CAM Name" has been selected as
the material name type setting.
When "Preset" is selected
The materials names are set using the "type + number"
format.
Type: CAM, C, CG, CGV, CGK, PC, V, VTR, VCR
Numbers: 1 to 9
When "Preset" is selected as the material name type setting,
the "Name" item will be displayed as shown below.
How to set the material names:
Press the OSD/TIME dial, and move the blinking part to the
position where the material type is to be selected.
Turn the OSD/TIME dial to select the material type.
Press the OSD/TIME dial to move the blinking part to the
position where the number is to be selected. Turn the OSD/
TIME dial to select the number.
When "User" is selected
Any material names consisting of not more than
10 characters (alphanumerics and symbols which can
be expressed in ASCII codes) can be set.
When "User" is selected as the material name type setting,
the "Name" item will be displayed as shown below.
How to set the material names:
Material names are set one character at a time.
Turn the OSD/TIME dial to move the blinking part to the
character input position, and press the OSD/TIME dial.
Next, turn the OSD/TIME dial to select the character, and
press the OSD/TIME dial to enter the selection.

2-1-4. Setting the freeze method

[10.1] Input Menu/SDI-IN1
2. Freeze Select
[10.2] Input Menu/SDI-IN2
2. Freeze Select
[10.3] Input Menu/SDI-IN3
2. Freeze Select
[10.4] Input Menu/SDI-IN4
2. Freeze Select
These are used to select the increment in which the SDI
input signal images are to be frozen (turned into still
images).
Frame:
The images are frozen in 1-frame increments.
Field:
The images are frozen in 1-field increments.
This is used when freezing moving images.
With interlace signals, however, diagonal lines and
moving parts appear jagged.
28 (E)