1. Basic operations
1-3-3. Selecting the key materials
Select the key materials using the A bus and B bus
crosspoint buttons.
1
Press the KEY-F/S button to set the crosspoint
buttons to the key bus material selection
mode.
The indicator of the KEY-F/S button blinks.
2
Select the key fill signal using the B bus
crosspoint buttons.
3
Select the key source signal using the A bus
crosspoint buttons.
4
Press the KEY-F/S button to release the bus
selection mode of the crosspoint buttons.
3
1, 4
AUX
PinP
KEY-F/S
MIX
BUS DELEGATION
TRANSITION TYPE
KEY-S
AUX
PGM
PVW
KEY OUT
CLN
1
6
2
7
3
8
4
KEY-F
PinP
AUX
2
WIPE
PinP ON
KEY ON
FTB ON
A
SHIFT
MV
CUT
9
5
10
B
SHIFT
AUTO
BKGD
1-3-4. Key transition
When the KEY ON button is pressed, the key transitions
(fades in) for the transition duration which has been set.
<Setting the transition duration>
[1] TIME/CBGD Menu
3. KEY Time
The transition duration can also be changed by turning
the OSD/TIME dial while pressing the KEY ON button.
When the KEY ON button is held down, the duration
setting is displayed on the OSD menu so the setting can
now be changed while checking what is displayed.
The key transition can also be executed by operating the
slide lever.
<Selecting the slide lever operation>
[13] Operation Menu
7. Slide Lever
10 (E)