Transition Between Pinp Materials - Panasonic AW-HS50E Mode D'emploi

1. Basic operations

1-4-4. Transition between PinP materials

When a PinP bus material has been selected, the effect to
be produced when images are switched can be executed as
a MIX transition. (Bus transition function)
  When one material set to the Dot by Dot mode and
another material have been switched, cut switching where
the images change in an instant is performed.
[1] TIME/CBGD Menu
7. PinP BUS Trans
Set the transition duration, and set the bus transition
function to "Enable" or "Disable".
While the transition is underway, the indicator of the
transition source button lights, and the indicator of the
transition destination button blinks.
When the transition is completed, the indicator of the
transition source button goes off, and the indicator of the
transition destination button lights.
When another signal has been selected while a transition is
underway, the processing for the transition will continue from
the interim point.
19 (E)