Pata Hard Drive (Cont'd.); Installing The New Drive; Formatting The New Hard Drive; Rtc (Real Time Clock) Chip - Lorex L200 Serie Manuel D'instructions

PATA Hard Drive (cont'd.)

Installing the New Drive

•
Place the new drive in the case, and reattach the holding screws.
•
Reconnect the cables in the same way as connected to the previous drive.
Reconnect the IDE Cable. Confirm that the cable is securely connected within the DVR
o
and to the Hard Drive.
Reconnect the Hard Drive power cable. Confirm the cable is securely connected to the
o
Hard Drive.
•
Replace the drive cover on the top of the DVR, and reattach with the screws.

Formatting the New Hard Drive

The New Hard Drive MUST be formatted.
If a new hard drive is detected, the system will
prompt you to FORMAT the drive. If you do not
choose to format the hard drive, the drive will not
be detected by the system.
If you choose to format a drive in this way, the drive
will no longer be readable by a regular PC.
Press the PLAY button to format the drive, or pres
the STOP button to cancel the format.
NOTE: If using multiple hard drives, the format will erase data on BOTH drives. When using two (2) hard
only
drives (L204/L208 ), it is recommended to back up any data on the existing drive before installing the
second one.

RTC (Real Time Clock) Chip

RTC (REAL TIME CLOCK) CHIP contains the system information and menu settings. If the battery for RTC
is discharged, the system will reset to default (factory) settings.
Appendix C: Replacing the Hard Drive
8CH STANDALONE DVR LOREX
(FW:2.50.85 UCODE:86)
VIDEO: NTSC
DISK0: 78533MB HD7280PLAT20
NEW DISK
DISK1: NONE
DISK0: PRESS [PLAY] FORMAT
[STOP] CANCEL
FORMAT ... DONE.
CD DRIVE: HL-ST DVD-RAM 1.07
67