Mounting The Bar Speaker And The Surround Speakers On A Wall - Sony HT-RT5 Manuel D'instructions

Mounting the Bar Speaker
and the Surround
Speakers on a Wall
You can mount the Bar Speaker and
surround speakers on a wall.
Notes
• Prepare screws (not supplied) that are
suitable for the wall material and strength.
As a plasterboard wall is especially fragile,
attach the screws securely in the wall
beam. Install the speakers horizontally,
hung by screws in studs in a continuous flat
section of the wall.
• Have the installation done by a Sony dealer
or licensed contractor and pay special
attention to safety during the installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
disaster, etc.
1
Fix the supplied wall mounting
brackets to the bracket fixing holes
on the bottom of the Bar Speaker
with the supplied screws so that the
surface of each wall mounting
bracket is as shown in the
illustration.
Fix the two wall mounting brackets to
the left and right fixing holes on the
bottom of the Bar Speaker.
Screw (supplied)
2
Prepare screws (not supplied) that
are suitable for the holes on the rear
of the Bar Speaker or surround
speakers.
More than 30 mm (1 3/16 in)
Bar Speaker: 4.6 mm
(3/16 in)
Surround speakers: 5 mm
(7/32 in)
10 mm (13/32 in)
Hole on the rear of the speakers
Wall mounting
brackets (supplied)
4 mm (3/16 in)
43
US