Usb Device - Sony HT-RT5 Manuel D'instructions

 Make sure that the on/standby
indicator on the surround speakers is
lit in green. If not, refer to "No sound
is heard from the subwoofer/
surround speakers." in "Wireless
sound Subwoofer/Surround
Speakers" (page 52).
No sound or only very low-level sound is
heard from the subwoofer.
 Make sure the AC power cord (mains
lead) of the subwoofer is connected
properly (refer to the supplied Startup
Guide).

 Press SW
+ on the remote control
to increase the subwoofer volume
(page 59).
 Make sure that the on/standby
indicator on the subwoofer is lit in
green. If not, refer to "No sound is
heard from the subwoofer/surround
speakers." in "Wireless sound
Subwoofer/Surround Speakers"
(page 52).
 The subwoofer is for reproducing
bass sound. In the case of input
sources that contain very little bass
sound components (i.e., a TV
broadcast), the sound from the
subwoofer may be difficult to hear.
The surround effect cannot be obtained.
 Depending on the input signal and
the sound field setting, surround
sound processing may not work
effectively. The surround effect may
be subtle, depending on the program
or disc.
 To play multi-channel audio, check
the digital audio output setting on
the device connected to the system.
For details, refer to the operating
instructions supplied with the
connected device.
50
US

USB device

The USB device is not recognized.
 Try the following:

Turn the system off.

Remove and reconnect the USB
device.

Turn the system on.
 Make sure that the USB device is
securely connected to the
port (page 9).
 Check to see if the USB device or a
cable is damaged.
 Make sure that the USB device is on.
 If the USB device is connected via a
USB hub, disconnect it and connect
the USB device directly to the Bar
Speaker.
BLUETOOTH
BLUETOOTH connection cannot be
completed.
 Make sure that the indicator (blue) of
the Bar Speaker is lit (page 12).
System status
During BLUETOOTH pairing Flashes quickly
The system is attempting to
connect with a BLUETOOTH
device
The system has established
a connection with a
BLUETOOTH device
The system is in
BLUETOOTH standby mode
(when the system is off)
 Make sure the BLUETOOTH device to
be connected with is turned on and
the BLUETOOTH function is enabled.
 Bring this system and the
BLUETOOTH device closer together.
 Pair this system and the BLUETOOTH
device again. You may need to cancel
the pairing with this system using
your BLUETOOTH device first.
(USB)
Indicator (blue)
status
Flashes
Lit
Unlit