Adjustment Of The Tub-Shaped Door; Disposal - oventrop Regudis W-HTE Notice D'utilisation

Tiling ready frame for the dwelling station Regudis W-HTE
Illust. 13: Placing the tiling ready frame into the wall
recess
8. Push the fixing brackets - short (2) towards the
wall planking from behind as shown in the below
illustration.
Illust. 14: Insertion of the fixing brackets - short
9. Screw the fixing brackets - short (2) hand-tight onto
the fixing brackets (1) which are already attached to
the frame.
10. You can align the frame with the wall planking by
moving the fixing brackets (2) and (3). Once you
have found the correct position, tighten the screws.
11. Fill the free gap in the wall with filler. The filler can
exert pressure on the frame during drying and
deform it. Pay attention to deformations during the
drying phase and correct them if necessary.
Please ensure that there is no filler on the
inside of the frame.
12. Cover the tub-shaped door of the tiling ready frame
as desired, for instance with gypsum plaster board
or tiles.
Please observe that the tub-shaped door is
not torsion-resistant. Rigid adhesive joints
may, for example, lead to cracks in the tile
joints when opening the door.
13. Insert the tub-shaped door with the hinge into the
frame. Make sure that the distance between the
tub-shaped door and frame is the same all around.
14. Fasten the screws in the hinge.
5.3

Adjustment of the tub-shaped door

You can adjust the tub-shaped door with the help of
the adjustment screws.
134409880-V01.07.2020
The fixing magnets keep the tub-shaped door
closed.
1
7
Illust. 15: Adjustment of the fixing magnet of the tub-
shaped door
(1) Wall covering
(2) Frame
(3)
Tub-shaped door
(4)
Wall covering
(5) Fixing magnet
(6) Adjustment screw
(7)
Base, e.g. masonry
1. Adjust the tub-shaped door to the desired level with
the help of the adjustment screws. The tub-shaped
door is recessed by screwing in the adjustment
screws. The tub-shaped door is raised by screwing
out the adjustment screws.
2. Change the closing force of the tub-shaped door to
the frame by modifying the position of the magnet.
The closing force of the magnet is increased by re-
ducing the distance between the fixing magnet and
the tub-shaped door.
6.

Disposal

NOTICE
Risk of environmental pollution
Incorrect disposal (for instance with domestic
waste) may lead to environmental damage.
f Dispose of packaging material in an envi-
ronmentally friendly manner.
f Dispose of the components appropriately.
If no return or disposal agreement has been made,
dispose of the product yourself.
f If possibly, recycle the components.
f Dispose of components which cannot be recycled
according to the local regulations. Disposal with
domestic waste is inadmissible.
Disposal
2 3 4
6 5
19