Alternative Fixing Option To Compensate For Different Wall Thicknesses - oventrop Regudis W-HTE Notice D'utilisation

Installation
6. Place the tiling ready frame into the wall at the de-
sired location and align the tiling ready frame in the
recess with the wall.
Observe the height of the final wall cover-
ing.
7. Tighten the fixing brackets at the frame. Screw the
fixing brackets into the wall.
8. Fill the free gap in the wall with filler. The filler can
exert pressure on the frame during drying and
deform it. Pay attention to deformations during the
drying phase and correct them if necessary.
Please ensure that there is no filler on the
inside of the frame.
9. Cover the tub-shaped door of the tiling ready frame
as desired, for instance with gypsum plaster board
or tiles.
Please observe that the tub-shaped door is
not torsion-resistant. Rigid adhesive joints
may, for example, lead to cracks in the tile
joints when opening the door.
10. Insert the tub-shaped door with the hinge into the
frame. Make sure that the distance between the
tub-shaped door and frame is the same all around.
11. Fasten the screws in the hinge.
5.2 Alternative fixing option to
compensate for different wall
thicknesses
The tiling ready frame is supplied with two additional
brackets. You can use them to clamp the tiling ready
frame to the wall planking.
Illust. 9: Alternative fixing option
(1) Wall planking
(2)
Fixing bracket - long (see illustIllust. 5 on page
17)
18
Tiling ready frame for the dwelling station Regudis W-HTE
1
2
3
3 mm
4
5
(3) Fixing bracket- short (see illustIllust. 5 on page
17)
(4) Fixing bracket (see illustIllust. 5 on page 17)
(5)
Frame
Proceed as follows for fixing:
1. Open the tub-shaped door (see Illust. 1 on page
16) of the tiling ready frame completely.
2. Remove the screws marked in the below illustration.
Illust. 10: Removal of the screws
3. Loosen the screw marked in the below illustration.
Illust. 11: Loosening of the screw
4. Remove the tub-shaped door from the tiling ready
frame and put the tub-shaped door with the loos-
ened hinge to one side.
5. Screw the fixing brackets (1) hand-tight onto the
frame (see Illust. 8 on page 17).
6. Screw the fixing brackets - long (3) hand-tight onto
the fixing brackets (1) which are already attached to
the frame.
Illust. 12: Fixing of the fixing brackets - long
7. Place the tiling ready frame into the wall at the de-
sired location and align the tiling ready frame in the
recess with the wall.
134409880-V01.07.2020