Daily Use; Stand-By Function - Zanussi ZDH8333W Notice D'utilisation

• Start a short programme (e.g. 30 minutes)
with moist laundry.

Daily Use

Start a programme without delay start
1. Prepare the laundry and load the appliance.
CAUTION!
Make sure that when you close
the door, the laundry does not
catch between the appliance
door and the rubber seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and options for
the type of load.
The display shows the programme duration.
4. Press the Start/Pause touchpad.
The programme starts.
Starting the programme with delay start
1. Set the correct programme and options for
the type of load.
2. Press the delay start button again and again
until the display shows the delay time you
want to set.
You can delay the start of a
programme from a minimum of
30 minutes to a maximum of 20
hours.
3. Press the Start/Pause touchpad.
The display shows the countdown of the delay
start.
When the countdown is completed, the
programme starts.
Change a programme
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.

Stand-by function

To decrease the energy consumption, this
function automatically deactivates the
appliance:
www.zanussi.com
At the beginning of drying cycle (3-5
min.) there could be a slightly higher
sound level. It is because of start of
the compressor that is normal for
compressor powered appliances
such: refrigerators, freezers.
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the
programme.
At the end of the programme
When the programme is completed:
• An intermittent acoustic signal operates.
• The indicator
• The indicators
on.
• The Start/Pause indicator is on.
The appliance continues to operate with the
crease guard phase for approximately other 30
minutes.
The crease guard phase removes creases from
your laundry.
You can remove the laundry before the crease
guard phase is completed. We recommend, for
better results, that you remove the laundry when
the phase is almost completed or completed.
When the crease guard phase is completed:
• The indicator
• The indicators
on.
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate the
appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter and empty the
water container when a programme
is completed.
flashes.
Filter and Tank comes
is on but does not flash.
Filter and Tank comes
25