Ensure you have good ventilation in the installation room to
•
avoid the back flow of gases into the room from appliances
burning other fuels, including open fires.
Exhaust air must not be discharged into a flue which is used for
•
exhausting fumes from appliances burning gas or other fuels. (if
applicable)
If the supply cord is damaged, it must be replaced by the
•
manufacturer, its Authorised Service Centre or similarly
qualified persons in order to avoid a hazard.
Obey the maximum load volume of 8kg (refer to the
•
"Programme chart" chapter).
Do not use the appliance if industrial chemicals have been used
•
for cleaning.
Wipe away lint that has accumulated around the appliance.
•
Do not run the appliance without a filter. Clean the lint filter
•
before or after each use.
Do not dry unwashed items in the tumble dryer.
•
Items that have been soiled with substances such as cooking
•
oil, acetone, alcohol, petrol, kerosene, spot removers,
turpentine, waxes and wax removers should be washed in hot
water with an extra amount of detergent before being dried in
the tumble dryer.
Items such as foam rubber (latex foam), shower caps,
•
waterproof textiles, rubber backed articles and clothes or
pillows fitted with foam rubber pads should not be dried in the
tumble dryer.
Fabric softeners, or similar products, should be used as
•
specified by the fabric softener instructions.
Remove all objects from pockets such as lighters and matches.
•
Never stop a tumble dryer before the end of the drying cycle
•
unless all items are quickly removed and spread out so that the
heat is dissipated.
The final part of a tumble dryer cycle occurs without heat (cool
•
down cycle) to ensure that the items are left at a temperature
that ensures that the items will not be damaged.
Before maintenance, deactivate the appliance and disconnect
•
the mains plug from the mains socket.
18
www.zanussi.com