Use; The Control Panel - Zanussi ZTA 210 Mode D'emploi

Use

The control panel

1 Programme chart
This will help you to select the correct programme for
drying.
2 Mains-ON light
Comes on when the appliance is switched on
(ON/OFF button - "AAN/UIT" pressed down) and
goes out when this button is released.
3 ON/OFF button - "AAN/UIT"
This button is used to switch the dryer on. At the end
of the programme, release this button by pressing it
again to switch the dryer off.
4 Low temperature button - "LAGE
TEMP."
Pressing this button allows drying to be performed at
a lower temperature, for delicate items.
The corresponding pilot light comes on.
5 Cool Tumbling Button
"VERFRISSEN"
By pressing this button the heat is cut off. This is
particularly useful to freshen the laundry (e.g. to
remove a persistent odour of moth-balls) or to dry
particularly delicate items.
In this case, you should select a longer drying time.
6 Start button - "START
After selecting the drying time press this button to
start the programme.
If the door is opened during drying or during a power
cut, this button has to be depressed again after
closing the door to allow the programme to continue.
7 Drying Time Selector Dial
The selector dial incorporates two drying cycles, one
of up to 150 minutes at a high temperature for cotton
and linen, and one of up to 100 minutes at a low
temperature for synthetic fabrics.
To set the machine to the selected time, turn the dial
clockwise until the time you want coincides exactly
with the pointer.
NEVER attempt to turn the dial in an anticlockwise
direction.
When selecting the drying time, you should
remember that it includes a 10 minute cooling phase
(position on the dial).
This phase should not be shortened, stopped or
avoided, as this could cause skin burns or damages
to the laundry.
Additional drying
If at the end of the programme, the laundry is still too
dump, set the dial for a further period of drying
(remembering to take into account the cooling
period).
9