Robert Juliat 1011+ Manuel D'utilisation page 45

3. USING THE " DIGI " MODE.
3.1.The ballast and the CAD are on ;
the " lamp on" command is given ,
but the lamp does not switch on.
Green
LED
on.
Green
LED
on.
Green &
red LED
off.
Green &
red LED
on.
3.2. Untimely extinction of the lamp.
Green
LED
on.
Green
LED
on.
45
robert juliat
Route de Beaumont F 60530 Fresnoy-en-Thelle phone: 33 (0)3.44.26.51.89 - fax: 33 (0)3.44.26.90.79 - www.robertjuliat.fr
TECHNICAL FILE
1200W HMI FOLLOW SPOT
message unchanged.
message displayed :
RJ LAMP LIGHTING
TRY FAILURE.
message unchanged.
message unchanged.
message displayed :
LAMP FAILURE
CHECK SECURITY
message unchanged.
No circuit number "lamp channel"
assigned : voir manual CAD :
- page 9.
Return to 1.1 and follow the
procedure.
Transmission Data error :
connection failure : check cable.
( refer to Tech. File p. 12 & 24 ).
Transmission Data error :
connection faulty or damaged -
check the wiring.
Important disruption on the Data
line : check the installation.
Bad Protocol : refer to page 7
- CAD 900 manuel.
Protocol recognition locked :
refer to page 15 - CAD 900
manual : The preferences .
Return to 1.1 and follow the
procedure.
Network cut off :
give the off command.
1011+B
VALID SINCE : 20.10.03
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.
Restart the
"LAMP ON"
procedure.