Technical Data - WAGNER W 867 E Mode D'emploi

W 867 E
•
CAUTION!
Wear breathing equipment: Paint mist and solvent vapors are
damaging to health. Always wear breathing equipment and only work in
well ventilated rooms or using supplementary ventilating equipment. It is
advisable to wear working clothing, safty glasses, ear protection and gloves.
CAUTION:
•
The spray gun is to be used only for paints and solvents with a 21°C (32° in UK) flashpoint
or higher (See information on the material tin. Hazard class A II and A III permitted).
•
Do not use the spray guns to spray flammable substances.
•
The spray guns are not to be cleaned with flammable solvents which have a flashpoint
under 21°C.
•
Caution against dangers that can arise from the sprayed substance and observe the
text and information on the containers or the specifications given by the substance
manufacturer.
•
Do not spray any liquid of unknown hazard potential.
•
The device may not be used in workplaces covered by the explosion-protection
regulations.
•
To avoid the hazard of explosion when spraying, provide for effective natural or artificial
ventilation.
•
There must be no sources of ignition such as, for example, open fires, smoke of lit
cigarettes, cigars and tobacco pipes, sparks, glowing wires, hot surfaces, etc. in the
vicinity during spraying.
•
Ensure that no solvent vapors are sucked in by the unit. Do not spray onto the unit!
•
The spray gun is not a toy; children must therefore not be allowed to handle it or play
with it.
•
Before working on the spray gun remove the power plug from the socket.
•
Cover areas that are
may transport paint mist over great distances and cause damage.
•
The units may only be used with a functional valve.
hose (Fig. 12 A, item 14) do not operate the unit further! Dismantle and clean the
ventilating hose, valve and diaphragm and replace the diaphragm if necessary.
•
Do not lay the spray gun.
•
The device is equipped with a thermal release which disconnects the device in case of
overheating. In this case, turn off the device, remove the plug and let the device cool
down for at least 1/2 hour. Eliminate the cause of heating, e.g. bent hose, soiled air filter,
slots for air intake covered.
With original WAGNER accessories and spare parts, you have the guarantee that all
safety regulations are fulfilled.
Max. viscosity
Max. flow rate:
Interior wall paint
Varnish paints, glazes, etc.
Power source
Power consumption
Atomizing output:
Double insulation
Danger of injury! Never point the spray stream towards
human beings or animals.
not to be sprayed. When working keep in mind that wind, for example,

Technical Data

170 DIN-s
375 ml/min
200 ml/min
230 - 240 V
570 W
130 W
If paints rises in the ventilating
~
GB
19