Setting Up - Adam Equipment WBZ Serie Mode D'emploi

EN
3.3

SETTING UP

• The scale comes with a stainless steel platform, packed
separately.
• Place the platform on the top. Do not press with excessive force
as that could damage the load cell inside.
• Level the scale by adjusting the four feet. A spirit level is located
at the rear panel.
• The scale should be adjusted such that the bubble in the spirit
level is in the centre of the level and the scale is supported by all
four feet.
• Attach the power supply module to the bottom of the scale and
plug into the mains.
• Press the [O/I] key to start. The scale will first display the software
revision, followed by a self-test.
• At the end of the self-test it will display zero weight, if the zero
condition has been achieved and the weighing unit that was in
use last. A stable and zero symbol indicators are also displayed.
© Adam Equipment Company 2011
4
Attach here