Introduction; Setting Up - Adam Equipment TBB Série Mode D'emploi

1.1

INTRODUCTION

The TBB 2610S and TBB 2610T are Single Pan Balances of unequal arm type with 3 beams.
They are often referred to as Triple Beam Balances. The maximum capacity is 2610g with the
supplied counter weights. Both the models come complete with counter weights (3) for weighing
up to 2610 grams above the basic capacity. The TBB 2610T has an additional counter weight
beam for Tare of up to 225 grams other than weighing up to 2610 grams.
1.2

SETTING UP

•
Unpack carefully. The balance consists of the main body and 3 auxiliary counter weights (2
each for 1kg loads, 1 for 500g load). Note that the counter weights are not 1kg or 500g
masses. They are used only to balance this amount of mass.
•
Place on a firm, level surface away from fans or open windows. Remove the rubber bumper
from under the pan support. Slide all the weights to the left. Make sure the 2 largest
weights fit into the notches on their beams. The front weight should point to zero.
•
To lock the TBB down using the optional Security lock, insert the locking mechanism into
the hole marked on the base of the TBB model. Follow the instructions supplied with the
lock and wrap the cable around a fixed object. Make sure the cable does not hit the beams
or the hanging weights.
•
Check the zero. The pointer on the right end of the beam should align with the zero mark.
Adjust the thumb screw on the left end of the beam, if necessary.
@Adam Equipment Company 2007
Capacity
Tare
Readability
Beam Calibration:
Damping
Protractor
Ruler
Lock Down Device
Density Determination
Pan Size
Overall Size (w x h x d)
Net weight
2610 grams with counter weights
+225 g on TBB 2610T only
0.1 g
Beam Range
Front
0-10 g
Beam
nd
2 Beam 0-500 g
rd
3 Beam 0-100 g
Magnetic
Inches ( " ) & centimetres (cm)
Uses Security Lock
152 mm (6") diameter
Stainless Steel
505 x 110 x 160 mm
(20" x 4.3" x 6.3")
2.7 kg (5.94 lb.)
4
Increment
0.1 g
100 g
10 g
(P.N. 8141, B4- 02/2007)
English