Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
GB
Stopping the engine:
4. Release the safety loop (2). The
motor switches off and the knife
is braked.
Knife stopping device:
•
Regularly examine the knife stop-
ping device:
Release the safety loop (2). The
motor switches off and the knife is
braked. The knife must stop within
7 seconds.
Level gauge
The level gauge (
side of the grass catcher (
aerodynamic air guidance provided by the
flap also optimises the filling.
GO
Flap open: grass catcher empty
STOP Flap closed: grass catcher full
Working Instructions
•
As far as possible, mow the lawn
when it is dry in order to protect the
turf.
•
Set the cutting height such that the
equipment is not overloaded.
•
Run the equipment at walking speed
in lines that are as straight as pos-
sible. For uninterrupted mowing, the
lines should always overlap by a few
centimetres.
•
Do not move backwards.
•
On slopes, always work across the
slope.
•
If the blade comes into contact with
a foreign body, switch off the engine
immediately. Wait until the blade is
stationary and check the equipment
for damage. Restart work only if the
equipment is undamaged.
80
18) is located on the
17). The
•
Switch off the equipment during long-
er breaks and for transportation and
wait until the blade is stationary.
•
Clean the equipment after each use,
as described in the "cleaning and
maintenance" chapter.
Cleaning and Maintenance
Have any repair and mainte-
nance work not described in
these instructions carried out by
a specialist workshop. Use only
original Grizzly replacement
parts. Risk of accidents!
Carry out maintenance and clean-
ing work strictly with the engine
switched off and spark plug con-
nectors removed. Risk of injury!
Allow the equipment to cool
before any maintenance and
cleaning work. Elements of the
engine are hot. Risk of burning!
Wear gloves when handling the
blade.
Cleaning and General Mainte-
nance Work
Do not tilt the equipment sideways
or forwards. Operating fluids could
leak out and the engine could be
damaged.
•
Always keep the equipment clean. To
clean, use a toothbrush or cloth but no
corrosive cleaning agents or solvents.
Do not use water to clean the engine
as it could contaminate the fuel sys-
tem.
•
After mowing, remove plant remains
that are stuck to the equipment by us-
ing a piece of wood or plastic. Clean
Publicité
Chapitres
Table des Matières
