Maytag MGR5870BDB Guide De L'utilisateur page 14

CARE & CLEANING
Self-Clean Oven
CAUTION:
It is normal for parts of the range to
become hot during a clean cycle.
To prevent damage to oven door,
do not attempt to open the door
when the LOCK indicator word is
displayed.
Avoid touching cooktop, door, win-
dow, or oven vent area during a
clean cycle.
Do not use commercial oven clean-
ers on the self-clean oven finish or
around any part of the oven as they
will damage the finish or parts.
The self-clean cycle uses above normal
cooking temperatures to automatically
clean the entire oven interior.
It is normal for flare-ups, smoking or flam-
ing to occur during cleaning if the oven is
heavily soiled. It is better to clean the
oven regularly rather than to wait until
there is a heavy build-up of soil in the
oven.
During the cleaning process, the kitchen
should be well ventilated to help eliminate
normal odors associated with cleaning.
BEFORE SELF-CLEANING
Turn off the oven light before cleaning as
the light may burn out during the clean
cycle.
Remove broiler pan, all pans and the
oven racks from the oven. The oven
racks will discolor and may not slide
easily after a self-clean cycle.
Clean oven frame,
door frame (area
outside of gasket)
and around the
opening in the door
gasket with a non-
abrasive cleaner such as Bon Ami* or
detergent and water. These areas are
not exposed to cleaning temperatures
and should be cleaned to prevent soil
from baking on during the clean cycle.
13
To prevent damage, do not clean or
rub the gasket around the oven door.
The gasket is designed to seal in heat
during the clean cycle.
Wipe up excess grease or spillovers from
the oven bottom to prevent excessive
smoking, flare-ups or flaming during the
clean cycle.
Wipe up sugary and acidic spillovers
such as sweet potatoes, tomato or milk-
based sauces. Porcelain enamel is acid
resistant, not acid proof. The porcelain
finish may discolor if acidic spills are
not wiped up prior to a self-clean
cycle.
SETTING THE CONTROLS
FOR SELF-CLEAN
1. Close oven door.
2. Press Clean pad.
CLEAN will flash and "--:--" will
light in the display.
If door has not been closed, "door"
will light in the display and a signal
will beep until the door is closed
and the Clean pad is pressed
again.
3. Press Preset (0) pad for "3:00" hours
of cleaning time for an average soiled
oven. Or, press the appropriate num-
ber pads for the desired cleaning time
between two and four hours.
4. Four seconds after entering the clean-
ing time, the oven door will automati-
cally lock.
LOCK will appear in the display.
CLEAN symbol
in the display.
°
0 0 0
HR
03:00
BAKE
LOCK
DELAY COOK STOP TIMER CLEAN ROAST BROIL
5. When the cleaning time has been
completed, the indicator word CLEAN
will turn off. The indicator word LOCK
will remain on until the oven has
cooled (approximately 1 hour).
HR
10 :00
DELAY COOK STOP TIMER CLEAN ROAST BROIL
When the oven has cooled, the indica-
tor word LOCK will turn off and the
door will automatically unlock.
TO CANCEL SELF-CLEAN CYCLE:
Press CANCEL pad.
If the indicator word LOCK is NOT dis-
played, open oven door. If LOCK is
displayed, allow oven to cool, then
open oven door.
NOTE: Depending on the length of
time the oven had been cleaning, it
may take up to an hour for the oven to
cool down. When the oven is cool, the
door will automatically unlock and can
be opened.
IF YOU WISH TO DELAY THE START
OF CLEANING:
1-3. Follow preceding steps 1-3.
4. Press the Stop Time pad.
STOP TIME will flash in the display
and display will show calculated
stop time based on the current time
of day and the clean time prev-
iously entered.
will appear
5. Press the appropriate number pads to
enter the time you wish the oven to
stop. A stop time can only be accepted
for later in the day.
EXAMPLE: If at 9:00 you set the
oven to clean for three hours, the cal-
culated stop time would be "12:00".
3 5 0
°
3 5 0
BAKE
LOCK
LOCK IS STILL ENGAGED.
DOOR CANNOT BE
OPENED UNTIL LOCK IS
NO LONGER DISPLAYED.