Miller Weld Oscillator Mode D'emploi page 16

A. Remote Start/Stop Switch
NOTE
Connect leads from normally-closed switch to terminals 2T21 and 2T22.
B. Remote Dwell On Left Control
C. Remote Dwell On Right Control
D. Remote Travel Width Control
NOTE
OM-1085 Page 12
For the remote start/stop switch to work, the Mode switch must be in the RUN
position.
24
9
Rear
26
9
Rear
If multiple Travel Width remote controls are desired, they must be switched using
relays with gold alloy cross bar type contacts or equivalent.
13
12
9
Rear
Remove jumper link between 2T24
and 2T51.
Connect leads from remote control
to 2T9 and 2T24.
Remove jumper link between 2T26
and 2T52.
Connect leads from remote control
to 2T9 and 2T26.
Remove jumper links between
1T13 and 1T14, and 1T12 and
1T49.
Connect leads from remote control
to 1T12, 1T13, and 2T9.