Commissioning; Connection; Inserting Or Changing The Remote Control Batteries - Renkforce MS-60i Notice D'emploi

8. Commissioning

a) Connection
Electrical connection:
• To take the device into operation, plug the enclosed mains adapter into a mains socket.
• Connect the output plug of the mains adapter to the voltage supply socket B3 at the rear of the radio.
• If you want to use the FM radio, uncoil the cable aerial B1 and align it accordingly.
• The internet radio is now ready for operation.
Connection of additional devices:
The device has one connection socket (3.5 mm jack plug) each for headphones and an external device,
such as an MP3 player, at the back.
• To connect headphones to the product, just connect the plug to the headphones socket B4 of the internet
radio. The speaker is automatically switched off and the music is played back on the connected head-
phones.
• To connect an external device to the radio, connect its output to the AUX socket B5 of the radio with the
corresponding cable.
Then switch on the external device and start playback. You need to switch the internet radio to mode
"AUX".
b) Inserting or changing the remote control batteries.
Before you can use the remote control, you need to insert the batteries.
Proceed as follows:
• First remove the battery lid of the remote control For this, push the lid on the rear downwards.
• Insert the two AAA batteries into the battery compartment. Ensure that the polarity is correct (plus/+ and
minus/-). This is marked in the battery compartment.
• Now push the lid back onto the remote control until it latches.
• The batteries are now inserted.
If you want to replace the batteries later, proceed as for insertion, but remove the old batteries
first.
43