Connect The Battery - Westinghouse WGen9500 Mode D'emploi

ASSEMBLY
FILLING THE FUEL TANK
1. Turn the generator OFF and allow to cool for a minimum
of two minutes before fueling.
2. Place the generator on level ground in a well ventilated
area.
3. Clean area around fuel cap and remove the cap slowly.
Only fill the tank from an approved gasoline container.
Make sure the gasoline container is internally clean and
in good condition to prevent fuel system contamination.
4. Slowly add the recommended fuel. Do not overfill. Fill
only to the red maximum fill ring on the fuel screen filter
visible in the filler neck.
Fuel Cap
Screen
Filter
5. Install the fuel cap.
Fuel can damage paint and plastic. Use caution when
filling the fuel tank. Damage caused by spilled fuel is not
covered under warranty.
Clean the fuel screen filter of debris before and after
each fueling. Remove the fuel screen filter by slightly
compressing it while removing it from the fuel tank.
12 | Westinghouse Outdoor Power Equipment, LLC
NOTICE
Maximum
Fuel Level
NOTICE
NOTICE

CONNECT THE BATTERY

A quick-connect battery plug is pre-installed on the battery.
Remove the cable tie securing the plugs then push firmly
to connect them.
Note: The generator is equipped with a battery charging
feature. Once the engine is running, a small charge
will slowly recharge the battery.
Quick-Connect Plug