Burkert 2030 Mode D'emploi page 5

Type 2030, 2031, 2032,
2033, 2037
Intended Use
Leaking medium when the diaphragm is worn.
▶ Regularly check relief bore for leaking medium.
▶ If medium is leaking out of the relief bore, change the diaphragm.
▶ If the media is hazardous, protect the area surrounding the discharge
point against dangers.
Danger due to loud noises.
▶ Depending on the operating conditions, the device may generate loud
noises. More detailed information on the likelihood of loud noises is
available from the relevant sales office.
▶ Wear hearing protection when in the vicinity of the device.
Danger of burns and risk of fire.
Quickly switching actuators or hot medium may cause the surface
of the device to become hot.
▶ Only touch the device while wearing protective gloves.
▶ Keep the device away from highly flammable substances and
media.
General hazardous situations.
To prevent injury, ensure:
▶ That the system cannot be activated unintentionally.
▶ Only trained technicians may perform installation and mainte-
nance work.
▶ Perform installation work and maintenance work using suitable
tools only.
▶ Do not transport, install or remove heavy devices without the aid of a
second person and using suitable auxiliary equipment.
▶ After an interruption, ensure that the process is restarted in a
controlled manner. Observe sequence.
1. Apply supply voltage.
2. Charge the device with medium.
▶ The device may be operated only when in perfect condition and
in consideration of the operating instructions.
▶ Observe the safety regulations specific to the plant for application
planning and operation of the device.
▶ The plant operator is responsible for the safe operation and han-
dling of the plant.
▶ Observe the general rules of technology.
▶ The exhaust air may be contaminated with lubricants in the actuator.
To prevent damage to property of the device, ensure:
▶ Supply the media connections only with those media which are
specified as flow media in the chapter entitled „6 Technical Data".
▶ Do not make any changes on the device and do not subject it to
mechanical stress.
english
5