Performing Longitudinal Cuts; Cutting Narrow Workpieces; Cutting Very Narrow Workpieces - Parkside PTK 2000 B2 Traduction Des Instructions D'origine

GB IE
Caution with incision cutting.
Operate the device only with a suction sys-
tem. Check and clean the suction channels
regularly.
Suitability of the saw blades:
- 24 teeth: soft materials, high chip
removal, rough cut image
- 48 teeth: hard materials, lower chip
removal, iner cut image
Performing Longitudinal
Cuts
(Figure 35)
Here, a workpiece is cut in its longitudinal
direction. One edge of the workpiece
is pressed against the parallel stop (14)
while the lat side lies on the saw table (1).
The saw blade guard (2) must always be
lowered onto the workpiece. The working
position during longitudinal cutting must
never be in a straight line with the cutting
line.
- Adjust the parallel stop (14) according
to the workpiece height and the desi-
red width.
- Switch on the saw.
- Place your hands with the ingers
closed together lat on the workpiece
and push the workpiece along the
parallel stop (14) into the saw blade
(5).
- Guide from the side with your left or
right hand (depending on the position
of the parallel stop) only up to the front
edge of the saw blade guard (2).
- Always push the workpiece through to
the end of the riving knife (4).
- The cutting waste remains on the saw
table (1) until the saw blade (5) is
back in its resting position.
50
- Secure long workpieces against tilting
at the end of the cutting process! (e.g.
unwinding stand etc.)
Cutting narrow
Workpieces
(Figure 36)
Longitudinal cuts of workpieces with a
width of less than 120 mm always have to
be cut with the help of a push stick (17).
The push stick is included in the scope of
delivery. Replace a worn or damaged
push immediately.
• Adjust the parallel stop according to
the planned workpiece width.
• Advance the workpiece with both
hands, making sure that you use a
push stick (17) as a pushing aid in the
vicinity of the saw blade.
• Always push the workpiece through to
the end of the riving knife.
Caution! In the case of short work-
pieces, the push stick should be
used from the beginning of the
cutting process.
Cutting very narrow
Workpieces
(Figure 37)
For longitudinal cuts of very narrow work-
pieces with a width of 30 mm and less, a
push block must be used without fail. There
is no push block included in the scope of
delivery! (Available from specialist shops)
Replace a worn push block as soon as
possible.
• The parallel stop should be adjusted to
the cutting width of the workpiece.