Service; Warranty Conditions - HT MPP300 Manuel D'utilisation

10. SERVICE

10.1.

WARRANTY CONDITIONS

This instrument is warranted against any material or manufacturing defect, in compliance
with the general sales conditions. During the warranty period, defective parts may be
replaced. However, the manufacturer reserves the right to repair or replace the product
Should the instrument be returned to the After-sales Service or to a Dealer, transport will
be at the Customer's charge. However, shipment will be agreed in advance. A report will
always be enclosed to a shipment, stating the reasons for the product's return. Only use
original packaging for shipment; any damage due to the use of non-original packaging
material will be charged to the Customer. The manufacturer declines any responsibility for
injury to people or damage to property
The warranty shall not apply in the following cases:
 Repair and/or replacement of accessories (not covered by warranty)
 Repairs that may become necessary as a consequence of an incorrect use of the
instrument or due to its use together with non-compatible appliances
 Repairs that may become necessary as a consequence of improper packaging
 Repairs which may become necessary as a consequence of interventions performed
by unauthorized personnel
 Modifications to the instrument performed without the manufacturer's explicit
authorization
 Use not provided for in the instrument's specifications or in the instruction manual
The content of this manual cannot be reproduced in any form without the manufacturer's
authorization
Our products are patented and our trademarks are registered. The manufacturer
reserves the right to make changes in the specifications and prices if this is due to
improvements in technology
10.2. SERVICE
If the instrument does not operate properly, before contacting the After-sales Service,
please check the conditions of the battery and of the cables. Should the instrument still
operate improperly, check that the product is operated according to the instructions given
in this manual
Should the instrument be returned to the After-sales Service or to a Dealer, transport will
be at the Customer's charge. However, shipment will be agreed in advance. A report will
always be enclosed to a shipment, stating the reasons for the product's return. Only use
original packaging for shipment; any damage due to the use of non-original packaging
material will be charged to the Customer
EN - 26
MPP300