Overview; Instrument Description; Description Of The Indication Leds; Master Instrument - HT MPP300 Manuel D'utilisation

4. OVERVIEW

4.1.

INSTRUMENT DESCRIPTION

4.2.

DESCRIPTION OF THE INDICATION LEDS

LED name
GREEN steady
POWER GREEN flashing
RED flashing
GREEN steady
GREEN flashing
RED flashing
STATUS
RED steady
GREEN flashing
MASTER
OFF
GREEN flashing
REMOTE
OFF
Table 1: Description of the indication LEDs on MPP300
4.3.

MASTER INSTRUMENT

MPP300 may be controlled only by the following MASTER instruments:
MASTER instrument
SOLAR I-V
SOLAR 300N
 All controls are sent to the instrument via RF communication (MASTER
instrument of Type 1) or via USB port (MASTER instrument Type 2)
 We recommend the user verifies that the software version (Firmware) in
the MASTER instrument to which MPP300 should be connected is
consistent with the indications given in Table 2. This information is present
in the initial screen shown when switching on the MASTER instrument.
The results of the measurements carried out by MPP300 are sent to the
MASTER instrument to which it is connected and shown on the master
instrument's display. All measures stored in the MASTER instrument's
memory can be subsequently displayed and can be transferred to a PC
Fig. 1: Description of the instrument's front panel
Status
MPP300 supplied by external power supply
MPP330 supplied by internal batteries
Batteries of MPP300 almost flat
MPP300 in synchronization phase before starting recording
MPP300 in recording phase
MPP300 memory full
Internal error of MPP300 (see § 4.3.1 and Message table in the
User Manual of the MASTER instrument)
MPP300 is connecting to the MASTER unit
MPP300 is NOT connecting to the MASTER unit
MPP300 is connecting to unit SOLAR-02
MPP300 is NOT connecting to unit SOLAR-02
Instrument type
1 (RF connection)
2 (USB connection)
Table 2: Characteristics of the MASTER instruments
CAPTION:
1. DC voltage inputs
2. DC current inputs
3. AC voltage inputs
4. AC current inputs
5. Indication LEDs
6. USB
MASTER instruments of Type
2, see § 4.3)
7. ON/OFF key
8. Connector for external supply
Description
Firmware
5.02 or higher
1.27 or higher
CAUTION
EN - 6
MPP300
connector (only
Fw update
Can be carried out by the user
Can be carried out by the user
for