Check Weighing And Target Mode (Check And Target Weighing); Check Weighing - KERN and SOHN ABS-N Série Mode D'emploi

15 Check weighing and target mode (check and target weighing)

• The check weighing or target mode can be applied for the application
functions (see chpt. 14).
• The balance starts in the mode, in which it has been switched off.

15.1 Check weighing

In many cases not the nominal value of the weighed goods is the decisive parameter,
but the deviation from this nominal value. Such applications are for example the weight
check of equivalent packages or the process check of parts in a fabrication process.
The indicators
,
located within the tolerance range.
These indicators are only functioning in check weighing or in target mode, otherwise
they cannot be seen.
The indicators provide the following information
Condition
<
OVR.RNG sample weight
<
HI.LIM sample weight
≤
LO.LIM sample weight
≤
UND.RG sample weight
<
Sample weight UND.RG
68
or
in the display show, where the weighed goods are
Grading
Beyond tolerance limit
≤
Upper tolerance limit
OVR.RNG
≤
Inside tolerance range
HI.LM
<
Lower tolerance limit
LO.LIM
Beyond tolerance limit
Indicator
No
indicator
No
indicator
ABS-N_ABJ-NM-BA-e-1614