Communication Parameters - KERN and SOHN ABS-N Série Mode D'emploi

16.3 Communication parameters

By calling-up a standard setting „MODE 1 - MODE 5" all communication parameters
are already preset (see chpt. 16.3.1).
The subsequent standard setting must be selected according to the printer (details see
the following table).
In the menu item „MODE U" all parameters can be set defined by user (see chpt.
16.3.2).
Standard
setting 1
Menu
MODE 1
selection
Manufactu Shimadzu
rer (Standard)
Baud Rate 1200
Parity None (8)
Stop bit 1
Hand-
Hardware
shake
Data Shimadzu
format Standard
Separator C/R
*only if the balance can send a feedback to the PC (without error: OK [C/R], at error NG [C/R].
82
Standard Standard
setting 2 setting 3
MODE 2 MODE 3
Shimadzu
Mettler
*
1200 2400
None (8) Even (7)
1 2
Hardware off
Shimadzu Mettler
Standard Standard
C/R C/R + L/F
Standard Standard
setting 4 setting 5
MODE 4 MODE 5
Sartorius A-D
1200 2400
Odd (7) Even (7)
2 2
Hardware off
Sartorius A-D
Standard Standard
C/R + L/F C/R + L/F
ABS-N_ABJ-NM-BA-e-1614
Setting for
User-defined
KERN –
settings
YKB-01N
MODE U MODE U
- -
user-
1200
defined
user-
None (8)
defined
user-
1
defined
user-
off
defined
user-
DF.1
defined
user-
C/R
defined