Mains Connection; Turning On The Power; Initial Commissioning; Connection Of Peripheral Devices - KERN and SOHN ABS-N Série Mode D'emploi

7.3 Mains connection

Power is supplied via the external mains adapter. The stated voltage value must be the
same as the local voltage.
Only use original KERN mains adapters. Using other makes requires consent by KERN.

7.3.1 Turning On the Power

 Supply power to balance via mains adapter. The display lights up and the
balance carries out a selftest.
In the ABJ models an automatic adjustment takes place.
 The selftest is completed when „OFF" appears on the display.

7.4 Initial Commissioning

In order to obtain exact results with the electronic balances, your balance must have
reached the operating temperature (see warming up time chpt. 1). During this warming
up time the balance must be connected to the power supply (mains, accumulator or
battery).
The accuracy of the balance depends on the local acceleration of gravity.
Strictly observe hints in chapter Adjustment.

7.5 Connection of peripheral devices

Before connecting or disconnecting of additional devices (printer, PC) to the data
interface, always disconnect the balance from the power supply.
With your balance, only use accessories and peripheral devices by KERN, as they are
ideally tuned to your balance.
ABS-N_ABJ-NM-BA-e-1614 19