Circuit Diagram - Hendi 233740 Mode D'emploi

Troubleshooting
If the appliance does function properly, please
check the below table for the solution. If you are
Problems
When connected to the electrical pow-
er supply, the temperature set & the
heating indicator lights on. But the ap-
pliance does not heat up.
When connected to the electrical pow-
er supply, switch on and temperature
set. The appliance heat up but the
lamp indicator does not light up.
Neither the heating indicator nor the
heating elements heat up.
Technical specification
Item no.
Operating voltage and frequency
Rated input power
Temperature setting
Net weight (approx.)
Protection class
Water protection class
Inside cabinet capacity
Outer dimension
Remark: Technical specification is subjected to change without prior notification.

Circuit diagram

220–240 V~
50Hz
still unable to solve the problem, please contact the
supplier/service provider.
Possible cause
• Thermal cut-out activated
• Heating element is burnt out.
• The indicator light is defective.
• The power plug is not connect-
ed firmly and correctly with the
electrical power outlet
233740
220 – 240 V~ 50Hz
800W
30°C to 90°C
22kg
Class I
IPX3
97L
460 x 448 x (H)785mm
Adjustable temperature 30-90°C
LED Lamp
Thermal cut-out Thermostat
150°C
Possible solution
Contact with the supplier/service
provider for repair.
Contact with the supplier/service
provider for repair.
Check the connection and make
sure all the connections are correct-
ly connected.
Heating
indicator
125°C
EN
7