Switching Off The Appliance; Interrupting The Wash Cycle; Changing The Wash Cycle - Thermador DWHD770W Serie Notice D'utilisation

When the interior lighting is switched off, the settings
▯
for emotionLight™ 1 to emotionLight™ 3 cannot be
selected.
Time Remaining Power Beam
display while the wash cycle is running)
While wash cycle is running, an optical display (time
remaining alternating with cycle indicator images) is
projected onto the floor under the appliance door.
You can set the Time Remaining Power Beam
All time remaining displays
Pre-wash
Cleaning
Rinsing
Drying
Using the Star Speed
Open the door and press the ON/OFF button
1.
Press the Star Speed
2.
be empty and without detergent for the preheating
period.
Press the Start button
3.
begin preheating. The Time Remaining PowerBeam
will project an image of a thermometer alternating with
the time remaining for preheat. Once the time
reamining counts down to 0:00, the Time Remaining
PowerBeam will project an animation of dishes
®
stacking, indicating that it's time to load the dishes.
Open the door to begin loading dishes for the first Star
4.
Speed wash. (Load dishes within an hour once the
®
preheating is finished).
Add detergent (use powder or liquid detergent – do
5.
not use tablets in this cycle), press Start button
and close the door within 4 seconds.
6. The Time Remaining PowerBeam
time remaining.
When the cycle is done, the Time Remaining
7.
PowerBeam will turn off.
®
The next Star Speed
8.
®
preheating (maximum of 60 minutes in between
cycles).
(Optical
®
®
cycle
®
button. The dishwasher should
®
)*
and close the door to
will now show the
®
cycles can run without any
Wash cycle end
The wash cycle has ended when "Finished" is indicated
on the digital display(s).

Switching off the appliance

Short time after the end of the wash cycle:
1. Press On/Off button
2. Remove the dishes when they have cooled down.
on or off.
WARNING
9
RISK OF INJURY
To avoid risk of injury, always use caution when
opening the door during or following a wash cycle
as hot water or steam may escape. Do not fully
open the door until water noises have stopped and
steam has subsided.

Interrupting the wash cycle

CAUTION
9
Expansion (overpressure) may cause the appliance
door to open and/or water to escape! If the door
was opened on an appliance which has a hot water
connection or is heated, always leave the door ajar
for several minutes and then close.
Open the door.
1.
2. Switch off On/Off switch
The LED's go out. The wash cycle is saved.
To continue the wash cycle, switch on the On/Off
3.
(
switch
4. Close the door.
(
Note: Your dishwasher is protected against unintentional
operation. If the appliance door remains open for more
than 4 seconds after pressing the Start button, the
operation will be paused. Press the Start button again
and close the appliance door.
®
Cancel a cycle (reset)
Open the door and press and hold the Start button
1.
)*
for approximately 3 seconds until the digital
@
display
2. Close the door.
Wait about 1 minute while the dishwasher drains.
3.
Open the door and press the On/Off switch
4.
)*

Changing the wash cycle

When the Start button
cycle cannot be changed. The only way a wash cycle can
be changed is by terminating the wash cycle (Reset).
(
.
(
.
again.
shows: "Program was terminated".
(
has been pressed, the wash
(
.
33